BMG Direct Drive mount for Aquila and Briss Fang duct w/ 40mm fan
Description
# BMG direct drive mount for Aquila with Briss Moto Fan duct and 40mm fans Nothing special - it works just fine. Mine, printed in ABS, shows no play at all and fits right from the printbed. Two-parts - for easier printing. If you wish, you can drill an optional hole to bolt it with an additional bolt to the upper bl touch mount hole. ### Print settings I've used 0.4mm nozzle, 0.5mm line width, 50mm/s, 0.2mm layer height Lower part prints without any problems, laying flat on its back. Build-plate only supports are needed for the additional mount place(although, the mount fits perfectly w/o this optinal skrew, I've decided to leave it as is). Notice that there are no support on the second overhang. Upper part prints better on a raft with build-plate only supports. If your slicer will want to support any of the 5 mount holes for the stepper motor - block them, they are perfectly printable as is. I've tested it on my printer and it is not tuned perfectly yet.
Statistics
Likes
0
Downloads
0