Ultra Pro One-Touch 3x3 Display Stand
Description
Trying to come up with a simple display stand to show off some trading cards in Ultra Pro One Touch cases. Any input on the 3x3 square model would be appreciated.. trying to figure out how to make it use less material and avoid supports. I added the "scooped" model where I hollowed out the back using paraboloid shapes. It does reduce the material, but I'm sure there's a better approach to be had? If not, it should be printable as is. I would double check the card slots for dimensions and scale based on your printer tolerances. I did up it about 1mm width and thickness compared to the actual one-touch dimensions. note: until this note is removed, this model is an untested, work-in-progress.
Statistics
Likes
0
Downloads
0