Magnetic Ooni pizza peel holder
Description
I've created this magnetic peel holder to manage the peels that were stored on top of the fridge. Bad position for vibrations and accessibility, a bit too high for my wife. Hardware needed: - 6 magnets 20 mm x 10 mm x 2 mm - resin glue to fix magnet in place I suggest printing the pice flat face down on the printing bed. Be careful doing so, if your Z isn't set properly you'll have a slightly smaller slot for magnets but nothing that a good knife can't handle I am not an expert so I will put here also the fd3 file in case you want to adjust it.
Statistics
Likes
0
Downloads
0