EUC Gotway Pedal Flipper
Description
A neat little pedal flipper I made for my Gotway wheels. I thoroughly disliked the versions that use double sided tape or require elaborate attachment mechanisms. So, I had this idea for a design, thought it'd be too flimsy and after couple alterations I can say I was wrong and it works really well. I've used this version for roughly 6 months and while they do break when making contact, they take just a couple minutes to print even at low speeds so it doesn't really matter. It should definitely fit on MSX 21 and Mten3, but I reckon it'll fit just fine on all Gotway wheels and pedals if not even different brands as well. Installation: It's going to be a very very tight fit. I usually use a hammer for gentle, but purposeful taps when I install mine.
Statistics
Likes
0
Downloads
0