
Up/Down Single Lane Modular
Description
Untested piece so far. Will update as required. This is a remix/addition to SpoolHeadsRacing's SR1 Track. Please see and credit: https://www.thingiverse.com/thing:5186591 https://www.youtube.com/channel/UC30g1A3Zlx5oGULbs82q_jw What is this piece? I wanted to make a dual lane piece of track, where the two lanes are a flat straight, but one lane goes up hill and the second lane goes down hill. The piece did not successfully print and wasted a lot of filament on supports I have cut the edge walls so they are thinner than the original sketch. Two single lanes, side by side, SHOULD have the same width as the centre wall on a dual lane track, and allow it to connect to a dual lane piece comfortably. Please see pictures for visual. Dimensions are 200mm (l) x 40mm (w) x ~44mm (h). This should equate to a 12.41 degree slope over 200mm length. (I'm not a mathematician though.) Supports to be touching baseplate only. Otherwise you will struggle to remove the pieces where the track connector goes.
Statistics
Likes
0
Downloads
0