RC V1 "Buzzbomb" Fieseler FI-103 EDF

Description

RC V1 or as nice decoration object Wingspann: 683mm CG: 42mm EDF: 50mm Changesun Lipo: 3-4s (1500-1800mah) Servo: 4x Emax note: until now it never flown. I crashed at take off cause of "brain error"! Print with PLA, try LW-PLA for the rear fuselage and elevator, otherwise you need much lead in the nosecone. Screw the nosecone.. all other parts glue with superglue. Use 6mm carbon tube for the wings and 4mm for the elevators. Use 1,75mm PLA or PETG for hinges Printsettings with Cura (other slicer not tested) wings, elevator, and rudder:  infill = 2.8%  infill pattern = gyroid  layer high = 0,25mm  retraction extra prime amount = 0,8mm³ (depends on printer)  Speed = 15-30mm/s (sometimes lower is better ;)  Slicing tolerance = middle  Wall line count = 1  Z seam position = back or sharpest corner  Combing-Mode = off  Support = tree  Support placement = touching buildplate  cooling = 0-30 % elevator and aileron flaps:  infill = 3%  infill pattern = grid  layer high = 0,15mm  retraction extra prime amount = 0,8mm³ (depends on printer)  Speed = 15-30mm/s (sometimes lower is better ;)  Slicing tolerance = middle  Wall line count = 1  Z seam position = back or sharpest corner  Combing-Mode = off  Support = tree  Support plaxement = touching buildplate  cooling = 0-30 % Fuselage: special parameter:  infill = 100%  layer high = 0,25mm  retraction extra prime amount = 0,8mm³ (depends on printer)  Speed = 15-30mm/s (sometimes lower is better ;)  Slicing tolerance = middle  Wall line count = 1  Z seam position = back or sharpest corner  Combing-Mode = off  Support = off (except if you using the data for smaller printer!)  cooling = 0-30 % if you like it feel free to leave a tp ;) Happy printing and Holm und Rippenbruch

Statistics

Category

Tags