FT5 TITAN VOLCANO PANCAKE EXTRUDER MOUNT with DUCT
Description
The FT-5 is down for some upgrades, and I needed a cooling solution for the newer vertical heat block from E3D that hooks to the volcano. Unable to test , and the silicone sock touches the duct but I've had a setup like this before and it worked fine. 40 MM cooling for the duct ; pancake motor (23MM?) it has room for a bigger one. I left the holes in the back in case it wants to warp and Needs spacers/ rear direct mount motor. The duct was made from scratch but, had printed the back to accept the "modular duct " components (see remixed from) I can upload all the step or F3D files if anyone wants them for modification. All other "remixed from" are where I got the STL's and converted the mesh to clean up the tolerances.
Statistics
Likes
0
Downloads
0