Dji mini Flaslight mounts
Description
Both of these are designed to be attached with a 1cm wide belt around the drone (reference in pic) and theyre angeled 45 degrees downwards. Note that you cant land or take off from flat surface with either of these attached. Bigger one for Odin needs to be printed in a hard material. I went with regular PLA and it works well. The flashlight is so big that it interferes with the altitude sensor so i designed it to be covered so the drone will enter ATTI mode. Consider that this almost doubles the weight of the drone and cuts the batterys flight time also in half. Smaller for i3E you need to print from softer filament so the loop has some flexibility and keeps the small light secure. I did it from TPU. This setup doesnt affect how the drone handles at all.
Statistics
Likes
0
Downloads
0