Anet E16 E12 Y-axis Rod Holder
Description
These are replacement brackets for the 8mm linear rod used on the Y axis of the Anet E10, E12, and E16. They are open ended which allows you to use longer linear rods if needed. I have 500mm rods on mine and they stick out 10mm or so on the front and back of the printer frame. You can use an M3 nut and screw to hold the rods in place and prevent movement. I recreated these from some old STL I found that doesn't seem to exist on thingiverse any longer and added countersunk holes so you can use the original screws. You'll need 3 of the standard Y rod holders and 1 with the end stop. Print without supports, and you may need to clean up the holes after the fact. If you print with generated supports you'll likely weld the seam together with support material.
Statistics
Likes
0
Downloads
0