Sheet music holder for drums
Description
This is my sheet music holder for my electronic drum set. It clkips on the horizontal beam. ## Constriuction - Put the printed screw into the holes on the stand and on the support piece - If the screw ius too tight in the holes, you can use piece of sandpaper wrapped around your drumstick handle to smoothen the holes. Rotate the sandpaper with the drumstick handle in the hole to create smooth even surface. - You can use a hammer with rubber ends to tap the screw gently through the holes. - Clip the oposite end of the support piece to the vertical beam of your drums. - use 2 40mm M5 screws and winged nut to secure the support piece to the vertical beam. - Tighten the winged nuts gently not to deform the vertical beam of your drums. - Set the final shape of the stand and use the printed nut to secure the stand piece to its final position.
Statistics
Likes
0
Downloads
0