Float Level Switch
Description
A float level sensor using a RAMPS optical endstop and a piece of 20mm electrical conduit. 1. The main body needs supports. 2. The float should be printed in vase/spiral mode with a extrusion width of 0.8mm 3. The connecting rod/flag 100% infill 4. Use a piece of clear filament as a light pipe for the LED indication 5. Use some soldering wire to add weight to the float, just wrap some around the rod above the float. I seal up the float by submerging the float and rod into acetone for a few seconds and blow dry. repeat 2 or 3 times.
Statistics
Likes
0
Downloads
0