TFT35 E3 v3.0 Case and Swivel Mount
Description
This case and swivel mount for the BTT TFT35 E3 v3 display is a remix/blend of the two Things cited. I have two of the TFT35 v3.0 screens, and people who saw the swivel mount setup I use for those asked if I could do the same for the TFT35 E3 v3. So here it is. I used BobP_'s mount pieces 100% "as is". For 3Deddy's case, I removed the swivel ball it had and added a mount point on the back matching BbP_'s TFT35 v3.0 case design. I also cleaned up the connection openings, adding the missing opening for a wifi module, reducing excessive gaps, correcting some opening locations, moved the standoffs onto the back cover, and slimmed the case down even further. All of the parts here are already in best print orientation. =================== UNTESTED!! ================= I did this case as a special request, but do not have an actual TFT35 E3 v3 to put into it. So instead of an actual display, I used three different stl models of the display, two from GrabCad and one from Thingiverse, for the design work. There were a couple of minor differences between the models, so I expect feedback on those if someone prints this kit and encounters any issues.
Statistics
Likes
0
Downloads
0