Inductive/Capazitive Mount for E3D v6 Bowden Carriage
Description
This Is A Remix Of Http://Www.Thingiverse.Com/Thing:638496. It Uses A 17/18Mm Inductive/Capazitive Zprobe. You Will Need To Print A Low Profile Fan Duct For Your E3D Hotend. Be Sure To Print This Part At A 100% Infill, Because The Sensor Doesn'T Seem To Fit Properly. Mine At 30% Broke. To Fit The Sensor Heat The Part Or The Sensor A Little Bit Up And Thread It Carefully Into The Part.
Statistics
Likes
10
Downloads
0