Kodeck (but it actually fits 120 cards)
Description
The original Kodeck only fit around 93 cards in dragonshields. I just stretched the middle part out along the Y-axis so it fits 120 for commander/edh - it should fit a similar number double-sleeved. It also fits an extra standard-sized die in each drawer compared to the original. The magnet slots are stretched as well, because I wasn't planning on using them (it holds itself open well enough on its own.) I'm sure they're still usable. I only did it for the swirly one with three drawers (no combination lock) because it was the only one I was gonna print. It's pretty easy to do in blender, though. It helps to sand the slider on all sides, and also sand the inside of the box itself. Depending on how well your printer is tuned, you might not have to do that. The drawers are kinda hard to get on right - i recommend putting the first side on, opening it all the way, jiggling the slider in so that the second peg up from the very bottom is aligned with the first notch in that gear, and then putting on the second side. It may take several tries and it will take quite a bit of force, but it's pretty sturdy once you get it on.
Statistics
Likes
0
Downloads
0