Flysky GT5 Wheel Donut
Description
Outer donut/wheel for the Flysky GT5 radio. The original foam donut works OK on the GT5, but I prefer a rubber/TPU wheel for better grip. To install, unscrew the center wheel and pull it off the transmitter shaft. Pull off the foam donut and replace it with the TPU printed version. NOTE: This is intended to be printed in TPU. It may work in a non-flexible material, but the dimension for the inside would need to change for it to fit properly. This is intended to have a very slight interference - but assumes that you are printing at a pretty high flow rate so if you print this and it is loose, change your settings to a higher flow rate to adjust or modify the model.
Statistics
Likes
0
Downloads
0