LK4 PRO Direct Drive Mount
Description
I've printed two direct drive mounts for my LK4Pro. And even though they have been described as dedicated to LK4 PRO, both of them were not aligned properly. In my case they are about 1 mm too much to front and about 2 mm too much to the right. That is why I decided to remix it, to fit my printer properly. On the base of remixed part (speeddrive_stock.stl), I`ve created a new sketch and shifted the mount 1mm to the back and 2 mm to the left. I`ve changed a bit geometry of the stepper motor plate to fit the stock drive perfectly without any margins. Layer: 0,15 Fill: 30% Material: PLA Support: YES It may be needed to file a little a holes for the metal insert of the rolls. They should fit tight, so i decided to not oversize them in a project.
Statistics
Likes
0
Downloads
0