BIQU H2 Extended 35mm to 40mm Heatsink Fan Adapter with BLTouch and CR Touch Mounts (The Claw Duct Compatible)
Description
This is the extended version of my adapter the BIQU H2 that lets you replace the 35mm heatsink fan with a 40mm one (4010 or 4020). This is is compatible with The Claw fang duct (https://www.thingiverse.com/thing:5202213). This adapter is only really needed if you want to run a quieter fan or need more cooling if running very high nozzle temperatures, otherwise you should stick with the 35mm fan. Depending on your setup and which fan you go with, you may lose some x travel to the left. Be sure to make adjustments to maximum x travel and your probe offset in your printer's config. Firmware Notes -------------- • Klipper • With 4010 Fan: [stepper_x] position_endstop: current setting - 5 position_max: current setting - 5 ... [bltouch] x_offset: -47.7 y_offset: 0 ... • With 4020 Fan: [stepper_x] position_endstop: current setting - 10 position_max: current setting - 10 ... [bltouch] x_offset: -57.7 y_offset: 0 ... Hardware ------------- Adapter: • (2) M3x6mm socket cap screws • (2) M3 nuts Fan: • (2) M3x6 socket cap screws Fan with BLTouch / CR Touch: • (2) M3x20mm socket cap screws BLTouch / CR Touch: • (2) M3x8mm socket cap screws • (2) M3 nuts Installation Notes ----------------------- • The rounded edge should be facing up and towards the front. If you want, you can buy me a coffee at https://ko-fi.com/vampyrex13
Statistics
Likes
0
Downloads
0