Reduplicator Y Axis Cable Chain 3030
Description
Set of parts to replace one of the Y carriage bearing holders to allow a 10mm x 10mm cable chain to be attached (and the wiring stress relieved with cable ties at either side) with a matching bracket to attach the cable chain perpendicular to a 3030 profile. For reference the dimension between the Y axis rod and 3030 profile is roughly 35mm - some tolerance is allowed for in the 10mm cable chain ends. Ideal for Omnomnomagon's Reduplicator project - hides the heatbed power and thermistor really nicely. It's a tight fit to the motor with a heatsink (per my picture) but it will fit snugly without anything catching. See my other designs for a Mk52 heatbed cover that puts the soldered heatbed wires out into the right location. I have put a JST-XH plug on my thermistor to allow cables to stay short, and still allow the bed to be moved before screwing down to the carriage. This bracket could also be used to attach 10mm cable chain to any 3030 profile with an M5 screw/T-Nut
Statistics
Likes
0
Downloads
0