Chimera+ Carriage for Ender 3 Pro
Description
This carriage is designed to adapt a genuine E3D Chimera+ hot end to the Ender 3 Pro. It uses one 4010 box fan (stock ender fan compatible) and two 4010 blowers (stock ender fan compatible). This is intended for the air-cooled version, I do not know if the water-cooled Chimera+ will work. There's every chance that this will not work for the clones, as the carriages I've tried designed around clones do not work on the real one. Note that the Chimera+ is slightly different than the original Chimera, with the easy difference being that the nozzles are now 20mm apart, not 18mm. This design has been optimized to allow the maximum build area to be utilized. This means that while both nozzles can reach 99% of the bed, the left nozzle requires the heater block to be turned 90 degrees. If you don't like that idea then move on, this was designed with that fact in mind. This is presently a work-in-progress thing because I have not yet finalized the fan ducts (you will notice they are presently missing). For what it's worth, the 4010 blowers were chosen as they are smaller and the materials I use require very little cooling to begin with, so the rather common 5015 is quite overkill and more difficult to package.
Statistics
Likes
0
Downloads
0