MP07-IONA-US Case
Description
WARNING: Installation needs a bit of force to flex the case and fit the PCB. I take no responsibility if you damage your PCB. This is a snap fit case for the MP07-IONA-US designed by Mellow PCB. The tolerances are somewhat tight, and PETG is highly recommended over PLA for this model. PETG has better layer adhesion, which needed for the snap tabs. PETG also not as stuff as PLA, which will be needed to fit the PCB inside. The MicroUSB side of the case will need to flex slightly as you push the PCB into the case in order to fit the port. Be careful when you do this, as the MicroUSB port is somewhat fragile. For a tighter fit, you can cut some electrical tape and stick it on the stand that sits above the 2 USB-A ports located on the lid of the case. 3-4 layers made the fit nice and snug for me. See provided photos for an example.
Statistics
Likes
0
Downloads
0