Shadow Lamp

Shadow Lamp

Description

The general idea is that this print will cast a pleasant shadow when a tea light or light source is lit in the middle of it. I designed it into a few basic print so a wide variety of printers could make this. The pins I designed are too small unfortunately and will snap when inserted. I found a way around this by inserting penny nails, wrapping the exterior with rubber bands, and then carefully supergluing the interior 4 edges and base plate. When this dried over night I was able to remove the penny nails and rubber bands for the final product shown in the photos. You will most like have to scale this print to your desired size.

Statistics

Likes

0

Downloads

0

Category

Decor