Simplified Light up Christmas Tree
Description
I liked the original design, but wasn't so keen on the wavy bottom which meant printing with a raft, so I chopped the bottom off for a quicker and easier print - nice and flat. I also simplified the base to match. And I sliced the star in half, so you can print them flat without supports. I'd prefer to glue two halves together, than worry about the rough surface from supports. Plus again they print quicker and easier. Unfortunately the use of stars in the design means that you are always going to get bad overhangs, not much you can do about that, just lots of filing post-print.
Statistics
Likes
0
Downloads
0