Prig dronerockingstand for Street League
Description
Have an extra spool of PETG and a few old fidget spinners? Oh and a hobby-grade supply of fasteners? Then you can have your own rocking launch stand! Looks cool and is fun to use. No more pre-load anxiety! Watch SFPV launch on his Instagram page https://www.instagram.com/p/CaOXLOXDWCl/ You can set your slicer for filament changes a couple layers after the first and before last layers to get the graphics to pop. Prints PETG: 1x Base – 40.5 grams 1x Base Mirror – 40.5 grams 1x Base Connector – 190 grams 2x Rocker (recommend printing on opposite sides for smoothness) – 52.5 grams for 1x 1x Rocker Front Support – 75 grams 1x Rocker Rear Support – 59 grams 4x Bushing Holder – 9.25 grams for 4x 2x Front Adjuster – 12.6 grams for 2x 2x Rear Adjuster – 11.5 grams for 2x 4x Vertical Support Clamp – 10.25 grams for 4x 2x Pat Platform Retainer – 10 grams for 2x 2x Pat Platform Retainer Mirror – 10 grams for 2x 4x Pad Bushing – 3 grams for 4x 4x Bearing Pin – 1.5 grams for 4x 4x Bearing Retainer – 2.75 grams for 4x 1x Cross Brace – 5.25 grams TPU: 2x Street Spec Pad – 14.25 grams for 2x 2x Street Spec Pad Mirror – 14.25 grams for 2x Hardware: 4x skate bearings (8m ID 22mm OD 7mm thick) 4x skate bearing spacers (8mm ID 14mm OD 0.5mm thick washer, or similar) 4x 16mm m3 flat head cap screws 4x 18mm m3 flat head cap screws 16x 12mm m3 flat head cap screws 8x 18mm m3 button head cap screws 4x 20mm m3 button head cap screws 4x 14mm m3 button head cap screws 44x m3 nylock nuts 4x 7/8” rubber grommets 4x 7/8” ID 1 1/8” OD o-rings
Statistics
Likes
0
Downloads
0