Pen holder for Anycubic Kossel Plus Delta 3D printer
Description
This is an accessory for Anycubic Kossel Delta Plus, to be able to attach a pen or pencil and use it as a pen plotter. It is designed to be attached to the nozzle plate using on of the screws at the bottom. The tube for holding the pen is wide enough for most pens, pencils and small amrkers, which can be adjusted/tightenened by inserting a screw in the hole. Possible improvements: - Add springs or elastic band holders to add some pressure between pen and paper without requiring too much precission when adjusting Z-height. - Use some sort of clamp instead of screw to make it easier to attach/detach pen
Statistics
Likes
0
Downloads
0