Raspberry Pi 3/4 DIN Mount
Description
Based on the ingenious design by [jwags55](https://www.thingiverse.com/jwags55). This remix is designed to fit more modern Raspberry Pi's (3 and later). The tolerances were tightened up so it should be a tight fit on 35mm DIN Rails and hold the board securely. Also this mounts the boards slightly closer to the rails. *Note: It's really easy for me to tune the parameters so if it's too loose/tight let me know in the comments and I can make some adjustments.* **Features** * Snap fits to DIN and Board (No screws needed) * Works with PLA * Low profile * No tools required * Easy and fast to print (No supports) **Printing Tips** * Use 4 perimeters * 4 Top/Bottom layers * 20% Gyroid infill * 20% Gyroid infill
Statistics
Likes
0
Downloads
0