ROYAL KLUDGE RK84 mechanical keyboard frame
Description
A custom frame to fit an Royal kludge RK84, Printed on a ender 3 with 0.2mm layer height to make sure the snap on tabs are on the right height. When you are printing this in 2 parts like i did i recommend adding a simple or decorative piece at the middle where the 2 pieces meet to reduce the flex, if you don't do this you will notice a flex where the seam is and the frame is easier to remove. This may also be avoided if you print it with a higher infill %, have not tested this. To ensure it will fit your keyboard well, the snap on tabs on the inside that are suppose to lock onto your keyboard might be a bit too long. you can very easily sand them back till you get the perfect fit.
Statistics
Likes
0
Downloads
0