iPhone stand charger
Description
This iPhone stand charger, has been tested with iPhones 6 up to iPhone 12 Pro with and without apple cases attached to them. The slicing was done with Prusaslicer at 0.15mm layer thickness. The design has been tested for printing with PLA and ABS and both comes out great. I did make a fairly wide brim in order to ensure that there was no warping on the ABS print, see picture where the orange charger is being printed. I made support in the slim tunnel where the wire will be held, as there is a slight overhang there, see included slicing picture.
Statistics
Likes
0
Downloads
0