Pi Camera bracket for bed mounting and 17mm lens adapter
Description
<h1>WHAT! a 17mm lens adapter for Pi Camera!</h1> That's right! A bracket to mount the Pi Camera with mounting point below hotbed in order to achieve good quality timelapse AND an adapter to use your 17mm lenses. The bed mount compartment is designed to adjust the position of the bracket left or right according to your needs. When you achieve the best view for your needs fasten the clamp and lock the bracket. The clamp fits a M3 nut to secure the whole body. Tested with a 73g wide lense from Ulanzi and the overall build is quite steady. Some vibrations were observed when the hotbed was changing directions quickly while printing small areas but the quality of the timelapse was not affected. You will need 2 hexagon M3 screws; the one to scerw the bracket with the case (front and back cover) and the other to screw the bracket with the bed mount.
Statistics
Likes
0
Downloads
0