MDD Direct Drive Clone Hero Me Ender 3 Gantry Plate
Description
Please consider leaving a like, make or comment on <a href="https://www.prusaprinters.org/prints/139086-mdd-direct-drive-clone-hero-me-ender-3-gantry-plat"> PrusaPrinters </a> Backstory I purchased one of the cheaper knockoff MDD v1.2 (Modular Direct Drive) plates and was unhappy when I found that the holes for the gantry plate were not aligning. Therefore I remixed the original gantry plate adapter (PM_CR-Ender_OEM-MS_Gantry_Adapter_5A) from the HMG6 to fit the two threaded holes in the MDD plate. The relative positions of nozzle and ABL mount as well as their heights are unchanged. I slightly modified the spacer for the hotend to make room for better air flow from the hotend cooler. Models I uploaded two versions, one with chamfers and one without. I always like to have rounded corners, since the printers are unable to print right angles anyway. However, if you don't like it use the _NoChamfer version. Printing: -No supports required -Infill: 35-50% -Walls: 4
Statistics
Likes
0
Downloads
0