Hanging Wastebasket Desk Mount
Description
Made this to hang off the edge of the shelf I have my 3D printer stored on. The ramp easily allows me to push filament scraps into the basket over the lip on my shelf. I have designed it to fit a 0.76" wide by 0.25" tall lip. Though, my lip is actually 0.75" wide, and I used a shim rectangle (mine was 0.24"x4.1"x0.08") printed separately to make everything snug. Just print a few at different heights to get it dialed. Print the inlet tray on its side and the basket open side up with Fuzzy skin. You may need to do a little bit of cleanup on the tab that the inlet tray locks into to get it to fit tight. P.S. Please don't print them all together like the photo, that was just for show.
Statistics
Likes
0
Downloads
0