Cr-touch 35 Degree No Bump Side Mount for Hydra
Description
This design was remixed from two other mounts that I'm too lazy to link. One was a bltouch mount that I remade to fix cr-touch and the other was the 35 degree no bump remix. This way I now have a cr-touch side mount with a 35 degree duct with no bump on it. I don't use cr-touch anymore so I don't plan on fixing this model, but it has a few problems. I forget what the problems are but I'm literally using it right now with a bltouch so it's not unusable. I think the tolerances are just bad and you might have to sand a bit. x_offset: -58 y_offset: -27 Be careful you don't adjust the cr-touch too high or it won't trigger in time and the nozzle will crash :) Only supports are in the image I showed. Good luck.
Statistics
Likes
0
Downloads
0