Ender 5 Plus Run Out Sensor Bracket for Micro Swiss Dual Extruder
Description
This is my First Thingiverse upload. I ended up getting the Micro Swiss Dual Gear Extruder and saw that I needed to print a part in order for the filament to line up from the run out sensor on the Ender 5 plus. I couldn't find one so I had to make one. This is a very simple design (Still Learning Fusion 360). I have two versions where you can fit a PC4-M6 or PC4-M10 Pneumatic Fitting. The hole is fairly small so it will be a tight fit. I didn't need to but depending on how precise you printer is you may need to tap the hole in order for the pneumatic fitting to screw in. Used four M3 x 8mm screws to secure bracket and used the original 4 screws that held run out sensor to attach to the bracket. I hope this helps. Happy Printing.
Statistics
Likes
0
Downloads
0