Yet another Spool holder (horizontal)
Description
Yes this is yet another spool holder design, I give Credit for the idea to the "Flsun Q5 filament spool holder v2 (horizontal) by alexeyzel August 22, 2020" https://www.thingiverse.com/thing:4576600 which i printed and used for quite some while on my Flsun Q5, to a lot satisfaction, Only thing that was bad on his design was that i had a lot more Spools with different sizes in the spool holes and printing for each one a support was not something i was willing to do, and without it tented to fall off. So i thought what would i make different, and the First answer was what if i make a cone-shaped top that i can put on his design,and this worked and works very good on the flsun. I was about to put that up on Thingiverse when i thought i would like to have the same on my CR-10S And how about 2 Cones on the bottom and top of the turntable. As result i created This design. it fits spools with hole diameter of 3.1cm to 99,9cm It is set up that together with the Turntable it will fit as well on the V-Slot rails, as well as on the Q5 of Flsun. but i did design both cones with the ability to have a 608 ball bearing so you can use it in other ways too. What do you need for it, that's not printable 4x 608zz ball bearings 1x M8 Rod or Screw with enough length for the different sizes of your spools. The bolt designs work both for me and are just so you can adjust the support ball bearings a bit in hight. the whole thing works just fine with only the middle ball bearing set up. The screw head file is in case you just use a rod, in the turntable setup, so the bottom cone has a stopper.
Statistics
Likes
0
Downloads
0