Pimoroni Microscope & Adafruit LED Ring Light
Description
This is an adaptor to put an Adafruit P5137 LED ring (70mm diameter) on to a Pimoroni microscope kit or lens. Simply print and press the LED ring into the gap slowly and carefully. It is designed to be a snug fit so that the light does not fall when you are using the microscope. You may have to adjust/calibrate your print settings to get it to feel right. I have left a divot on either side of the gap so that you can get the LED ring out again with a gentle bit of force. The outer divot lets you run the necessary wire through. I'd recommend the stock Ultimaker Cura 0.1mm layer height settings and adding a thick bottom layer for a clean print. 20% infill or higher should work. I printed with 3x 1mm walls. Pimoroni Lens: https://shop.pimoroni.com/products/microscope-lens-0-12-1-8x?variant=31885093371987 (UK) Adafruit LED Ring: https://www.adafruit.com/product/5137 https://thepihut.com/products/cool-white-led-ring-light-with-usb-cable-and-on-off-switch-70mm-diameter-5v (UK) If you'd like to adapt this adaptor for other ring lights or accessories, be my guest! You can move the inner and outer wall of the gap to do so!
Statistics
Likes
0
Downloads
0