Sprusa - The Prusa Spool Cradle
Description
V2 UPDATE: - Increased size of rod holes - Increased space bearing is in since some spools were a bit too thick to run in that space - Decreased the height of the rounded guides above the bearings to work better with completely full spools Here's a spool holder for your Prusa i3! It uses 3mm (dia) by 15mm rods and 8mm by 4mm bearings. I'd suggest using the settings I have here because anything lower and the rod holes can split. They also may need a bit of pre-drilling. With .1mm it takes about 12 hours to print.
Statistics
Likes
1
Downloads
0