Hexagonal Drawers for uHook Pegboard
Description
<h3>Hexagon Drawer Set for Pegboard - uHook edition</h3> <b>Work In Progress</b> The state of this project is as you see it now. I'm satisfied with the quality of the work. But the size could be better. I'm using uHooks and I'd like the hexapods to be flush up against one another. So, a little wider and taller. I'll have time to address this soon but not today. Meanwhile. Definitely works, I just want to tweak it. <hr> Inspired by all the Hex Drawer sets out there. But this one I made from scratch. I modified the uHook Back I originally used here: https://www.thingiverse.com/thing:5223576. The Case fastens to the Back with one short screw: M3x6mm. The Drawer has 1mm walls & 2mm face with a hex-hole instead of a knob. Case is solid with 2mm walls. Print as shown. I print on Draft with a small 5mm Raft. Don't judge me. <b>modified</b> 2022-03-05: original drawers were tight. narrowed 'em a bit. Made the hex-hole larger. Thickened the drawer face (to 2mm.) Might further strengthen drawers, but for now they're plenty good. Go for it. --hexDrawerx1.stl - one container --hexDrawerx2.stl - two containers divided by length --hexDrawerx2b.stl - two containers divided by width M3 screws: https://www.amazon.com/dp/B01HBN0VXO/ uHooks: https://www.amazon.com/dp/B005A3QR2W/
Statistics
Likes
0
Downloads
0