GSG Firefly Magazine Retainer
Description
Magazine base plate retainer for Sig Sauer Mosquito/ GSG Firefly. I was installing the +4 follower I found on here (works great by the way-thing no. 3321753) and this piece slipped out from under my thumb and entered a hole in time and space never to be seen again. Didn't trust running the mag without it, didn't want to let a good mag go to waste, so here we are. Works just fine with PLA, wouldn't recommend leaving it out in the sun for extended periods of time, if you're somewhere hot, use PETG. Print with the two bumps facing up, normal support underneath. Takes about 6 minutes to print.
Statistics
Likes
0
Downloads
0