Skagen Falster 2 watch charging stand
Description
# Overview Remix of plamennicolov's original design, to work with the Skagen Falster 2 smartwatch. This remix has been itterated on and tested to make sure it gets the tightest fit around the Falster 2 charging puck, whilst still being able to remove the puck. A small hole has been added to the rear of the charging stand which a small pen can be inserted to easily push the puck out/align it as desired for your watch. # Print settings - orientate the print upright, the same as you would place the stand on a table - add tree supports, then post-print use needle-nose pliers to remove the internal supports - 5-10% infill (I chose 5%) - brim is optional, recommended if you have issues with your adhesion generally # Fitting / Removing Charging Puck It's designed to be a tight fit, otherwise, the puck will wobble around which is really quite annoying. To achieve that, you need a bit of gentle force to push in the puck. Thread the USB through the puck hole and out the bottom, then align the puck and push firmly until it clicks in place. To remove, get the blunt end of a pen/pencil and push the hole on the reverse to pop it out.
Statistics
Likes
0
Downloads
0