Adventurer 3 Filter Holder
Description
This is a filter holder I made for my adventurer 3. It is 50mm x 50mm x 25mm Tall. The sides are solid and you will have to drill out your own magnet holes. I just used some small neodymium magnets. I cut 3 squares of carbon filter and placed it in the filter. This reduced all smell from the printer completely. This is not a remix, but an original version I made. Thanks 3/29/22 Redesigned the filter holder. Made holes larger on bottom, shortened the magnet holders and also created a groove for a rubber seal.
Statistics
Likes
1
Downloads
0