Hex Key
Description
Hex Key Remixed from my original Hex Driver Bit Holder (Sept 08 2020). Compact hex driver with magnet to hold hex bit. Nearly the same as the original but a bit smoother with a space to insert a 6 x 2 mm magnet (easily sourced on Amazon or Ebay). If you print this version without the magnet the hex bit will be loose (use the previous version for a push fit). Use the gcode to print directly - otherwise set up your slicer to pause at layer 48 (if using the settings below) and drop in the 6 x 2 mm magnet. Resume print. SETTINGS: Orientation already aligned in the files with the open hex face upward Layer height: 0.2 mm Infill: 10% Brim: 4 mm Supports: None Material: PLA, PTEG, etc Regards, Paul
Statistics
Likes
0
Downloads
0