Wall Cabinet Pullout Tray
Description
A simple tray to get access to the spices in the back. Attached to 8" drawer slide, but I bet a 10" would work just as good or better. Designed to use the whole width of my print bed. Hardware: 2 - 8" or 10" drawer slides 4 - 1/4" long screws 4 - M5x8 bolts and washer You could glue the two pieces together, but if you crank down the bolt hard enough, its not going anywhere. I also used a 3/4" spacer when installing to avoid the hinges on my cabinet.
Statistics
Likes
66
Downloads
0