scx 24 receiver tray
Description
this is a receiver box to relocate the stock receiver to the rear of the vehicle. it uses the stock M1.5 hardware. this mounts the receiver where the stock battery tray was. fore use remove the receiver from the stock box. the receiver is then placed in the new tray and mounted to the vehicle. the box is designed for the on off switch to be removed from the board. this is designed to work with the low cg battery tray (SCX24 mock motor batt holder or scx24 mock batt motor W/O vertical body mounts). note that you will need to extend the servo lead when using this. if crafty enough you can either solder lead extension onto the existing servo wire or make a small extension. the box was designed using the axial AE-6. it is not confirmed to work with the newer v2 electronics.
Statistics
Likes
6
Downloads
0