Craftsman FF Tractor Hydrostatic Drive FAn
Description
Printed this and tested on a Shaft for a Craftsman FF tractor. These Hydrostatic Drive fans are impossible to get any more. I will be looking at printing more items specific to the tractor. Us collectors have no where else to buy some of these items. Print at 100% Infill, No Supports and your choice of adhesion. V2 - Mimics original design with the center shaft cutout just above center and should allow for Set Screws to be inserted. Also is now 7" In Diameter as original. - Will need Supports for middle section and likely some finish work after printing. V3 - Keeps the Center Cutout at the bottom of the Build plate, just have to install it with the flat side towards the Hydrostatic Drive. Scaled down to 7" Total Diameter.
Statistics
Likes
1
Downloads
0