Ender 3 V2 x-axis mount
Description
I wanted to mount my PI Camera from the x-axis and found HanKimMN Ender 3 V2 X Axis Mount. However, I have the CR Touch installed, and the head couldn't contact the limit switch. To address it, I took the same general design, and cut out portions of the right side in order to leave room. The clip from HanKimMN's original design is used to hold the mount in place. The extension arm reduces the number of joints needed for the entire setup, which isn't necessary, but does work nicely with sneaks articulating camera mount. If it helps you, please post a make.
Statistics
Likes
0
Downloads
0