St. Patrick's Day Keurig Drip Tray
Description
Simple remix of pixil3d's Keurig drip tray, repurposed for a little festivity on St. Patrick's Day. Note: the 8-bit heart tray of pixil3d's that I printed has warped a bit from hot mugs sitting on it after a couple weeks of use, so given this is also PLA, I expect the same. I printed in HTPLA with intentions of annealing before use for better heat resistance, but I didn't end up doing it. If you tend to leave your coffee sitting on the Keurig for a few mins, it may be worth giving annealing, or a higher-temp material like PETG or ABS, a shot; but if you only plan to use it for a short time, it's probably not a concern.
Statistics
Likes
2
Downloads
0