DTAP Micro Voltmeter [0.28" display]

Description

A smart voltmeter housing that lets you monitor your camera or monitor's voltage at a glance. Printed in nylon and tested in PLA (PETG would probably also be good). All you need is a 0.28" micro voltmeter, a bit of wire and a connector of your choosing (I use DTAP). The cable used is Van Damme 2 strand installation wire. The through hole lets you mount the device anywhere in any orientation with a 1/4 20" screw Assembly: solder wires onto voltmeter. Make sure they fit inside the shell. The wire and two shells are held in place with CA glue and clamped.

Statistics

Category

Tags