Adventure Force Spectrum Extended Battery Door & Battery Tray
Description
The Expanded Battery Door is remixed from the one by Salvin3649. I added some chamfers to allow it to be printed on its side with minimal supports (only required under the screw post area). I also angled the retention nubs to allow them to be printed without supports and removed about 2mm of length from them because the originals were too long to work in the blaster. Fits the OOD 950 Graphene 3s Lipo now. Print on its side, supports under the screw area only. The original expanded battery door can be found here: https://www.thingiverse.com/thing:4748014 The Battery Tray is remixed from the one by opcolu. I trimmed a few mm off of the tops of the walls at the end so that the expanded battery door could fit with it. Print on its bottom. No supports required. The original battery tray can be found here: https://www.thingiverse.com/thing:4706832
Statistics
Likes
5
Downloads
0