Adjustable IKEA motion sensor mount
Description
This mount is adjustable up/down and left/right. There are two backplates to choose from: -One for two 10x2mm magnets -One with a flat surface for either taping/gluing in place. Or perhaps print it with 100% infill and drill a hole for whatever size screw you want to use. Hardware required: 2x 14mm M3 bolts. 2x M3 nuts. (Optional: 2x 10x2mm magnets) Parts needed for print: 1x Backplate (Choose what version you want) 1x Joint 1x Connector (this one goes into the motion sensor) 2x Wedges (these lock the connector into the back of the motion sensor) I would also recommend printing with supports for the magnetic backplate just so the magnets doesn't stick out from the holes.
Statistics
Likes
2
Downloads
0