Linear Rail Snapmaker 2.0 A350
Description
Linear Rail holder for Snapmaker 2.0 A350. Suitable for the following linear guides SBR16 750mm - 800mm https://de.aliexpress.com/item/1005001468106943.html?spm=a2g0o.productlist.0.0.5b8f404cZnIwAE&algo_pvid=34808798-e00a-45da-9fa1-ac3e6492ac46&algo_exp_id=34808798-e00a-45da-9fa1-ac3e6492ac46-10&pdp_ext_f=%7B%22sku_id%22%3A%2212000016238249293%22%7D&pdp_pi=-1%3B66.28%3B-1%3B5.0%40salePrice%3BCHF%3Bsearch-mainSearch The following screws are also needed: Flat head M5x20 PLASTIC SCREWS EJOT PT® WN 1452 2.5 x 6mm The 4 adapter plates are mounted on the 4 slides. When doing so, the holes of the slides and the alignment of the bed based on the linear guide must be observed. The distances between the holes are 30 x 32 mm each. Then the holders are clipped in at the front and rear. The linear guides are now pushed through and then the front carriage and then the rear carriage are inserted before it then goes through the 2nd holder. Align the two linear guides and then use a 1.5mm drill to make a mark on the linear guide for all 4 holders, then pull the guide to one side and drill 2mm deep holes with a 2.5mm drill. Put the guides back in position and fix them with the plastic screws.
Statistics
Likes
1
Downloads
0