Smartphone Stand #2 (V-shaped)
Description
This is a very thin folding smartphone stand. [Remaining problem] When using, the hinge part becomes loose. The smartphone is placed in this state, the stand will move so as to narrow the V-shaped angle, and it will become unstable. [size] height: 21.5mm, thickness:6mm, length:68mm [screws to use] M3 CAP 18mm x1 It is recommended to use glue to prevent the screws from loosening. No nuts needed. [print conditions] -printing type: FDM -printer: Original Prusa i3 MKS -filament: PLA -support: no -brim: no -raft: doesn't matter -print directions: please refer to the photo [revisions] 2022/03/28 I change the hinge shape. I'm sorry, the photos are still the old version. 2022/03/27 I change the print directions and I changed the fine shape. 2022/03/27 The top and bottom chamfers have been made slightly larger to make it easier to open. 2022/03/26 I made the length a little longer. And I narrowed the slot a little. 2022/03/25 I changed the shape of the hinge part a little. Sorry, this has not been print tested. 2022/03/24 A chamfer was added to the tip to make it easier to open.
Statistics
Likes
320
Downloads
0